Sizing guide bracelets

▶ PRINTING OPTIONS

To get the best results, you will need to go to ‘printing options’ before printing and ensure that the ‘page scaling’ option in the print dialogue box is set to 'none’. The Cartier Wrist Sizer must be printed on a full letter size page (8 ½ x 11 inches). To check that the Wrist Sizer has been printed properly, use a ruler to measure the sample below. It should measure exactly 2 cm.



rule example


▶ HOW TO USE THE CARTIER WRIST SIZER

  • Cut out the paper Wrist Sizer and follow the instructions below.
  • Make sure that the numbers are on the outside of the paper Wrist Sizer and insert the pointed end through the slit you have cut at the other end indicated [cut here]. Place your hand through the Wrist Sizer and pull the pointed end until it fits comfortably on your wrist.
  • The number that lines up with the edge of the slit is your wrist size.
  • You can also use a tape measure; or if you don’t have one, use a small piece of ribbon or cord. Wrap it around your wrist and measure the length using a ruler.


bracelet illustration

CHOOSING
THE SIZE OF
A LOVE BRACELET:

The usual bracelet sizing rules differ slightly in this case due to the design of the LOVE bracelet. Once you have found your size using the Bracelet Sizing Chart, Cartier recommends adding one centimetre for a tight fit and two centimetres for a loose fit.


Please note that the Cartier Wrist Sizer is an indicative guide only and thefore may not be an exact measure.